MicrowaveRepair.center (844) 393-5858Mon–Sat, 8am–8pm Book a visit
The keypad of a built-in microwave in a tall cabinet, a small padlock symbol lit on the plain display, the mesh-window door closed on an empty glass turntable.

GE Profile FOOD: the microwave thinks nothing was put inside

GE Profile microwaves track the door.

(844) 393-5858

Mon–Sat, 8am–8pm

  • Mode, not a failure
  • No repair needed
  • Source: GE Profile

Book a visit

Three short steps, about a minute.

or call (844) 393-5858

What FOOD
actually means.

GE Profile microwaves track the door. If a program is started and the door has not been opened since the last use, the control assumes the cavity is empty and shows FOOD rather than running with nothing inside to absorb the energy.

GE Profile microwave display

What to do when FOOD shows on the microwave

Kind of codeMode, not a failure

Something was switched on rather than something wearing out: a child or control lock set by a long press on the wrong pad, after which no key answers, a demo or showroom setting that lights the display and turns the plate while nothing warms, a Sabbath setting that dims the panel and mutes the beeps, or a clock left blinking after an outage that holds the keypad until it is set. No part is needed; a key sequence from the manual switches it off again.

Usually leads toNo repair

Open the door, make sure the food or drink is in place and close it firmly.

Shows up asWhat a Microwave Error Code Is Telling You

A microwave error code may be a letter and a number on the display, a lock or demo word, a row of dashes, or a beep with a blinking clock, and it can show while the microwave still heats or block every key until it is cleared.

MakeGE Profile

GE Profile microwaves repaired where they hang or sit, whether it is the vent fan, the cavity lamp, the keypad or the heat that gave out.

SourceGE Profile PEB7227 built-in and PES7227 countertop microwave owner's manual

The FOOD prompt appears in the PEB7227, PES7227 and PEM31 tables and again in the PWL1126 drawer manual.

Before you book,
in this order.

Each step comes from GE Profile's own guidance for FOOD on its microwaves. Follow it to the end: the last card says whether this is a visit.

01

Open the door, make sure the food or drink is in place and close it firmly.

02

Start the program again.

03

If FOOD appears even after the door has been opened and closed, book a visit so the door switch can be tested.

Cleared?

The code has gone and a mug of water heats again without a new part. If it comes back this week, or the food starts coming out cold in the middle, mention in the booking that it came back.

What not to do

FOOD is a safety prompt, not a heating problem. When it appears after the door has clearly been opened, the control is not seeing the door move, which points at a door switch.

What you may
notice with it.

The microwave problems FOOD tends to arrive with. Answer these at the microwave before anyone is booked.

All problems

Before you call

What a Microwave Error Code Is Telling You

All 7 causes, cheapest first

It also comes with

Close view of the control panel beside the side-hinged door with a mesh window of a built-in stainless microwave in a tall kitchen cabinet, a few abstract lit segments on its small display, the microwave cavity dark behind the closed mesh window. Problem

What a Microwave Error Code Is Telling You

7 causes, cheapest first

No repair indicated

Nothing to repair.

Something was switched on rather than something wearing out: a child or control lock set by a long press on the wrong pad, after which no key answers, a demo or showroom setting that lights the display and turns the plate while nothing warms, a Sabbath setting that dims the panel and mutes the beeps, or a clock left blinking after an outage that holds the keypad until it is set. No part is needed; a key sequence from the manual switches it off again.

How to read what your microwave is telling you

GE Profile
microwaves.

GE Profile microwaves repaired where they hang or sit, whether it is the vent fan, the cavity lamp, the keypad or the heat that gave out.

GE Profile microwave repair

More GE Profile codes

F3PFERRLOCOVEN TOO HOTF1F2F4F5

Mode, not a failure on other makes

Bertazzoni LOCKBosch LOCK ONCafé CONTROL LOCKEDDacor LOCK ONFisher & Paykel LOCKFulgor Milano LOCK ONGaggenau Demo modeJennAir LOC
All 46 codes of this kind
A stainless microwave hood combination mounted under white shaker wall cabinets in a US kitchen, the microwave's side-hinged door closed with its dark mesh window, a plain glass bowl visible faintly on the glass turntable inside the microwave, the lamp on its underside glowing softly onto a cooking surface that is cropped and out of focus at the bottom edge. GE Profile builds this

Microwave hood combination

The microwave that hangs from the wall cabinets above the burners, heating food in its cavity while its own fan, light and filters handle the steam and grease rising from the pans beneath it.

 A stainless built-in microwave set flush into a tall walnut cabinet at eye level in a US kitchen, a thin steel trim frame around the microwave, its door closed with a dark mesh window and a plain glass dish on the glass tray inside the microwave, soft daylight from the side. GE Profile builds this

Built-in microwave

A microwave set into a tall cabinet or a wall of cabinetry at eye level, either a countertop body wrapped in a trim kit or a true built-in model, including speed and convection microwaves that brown as well as heat.

 A stainless microwave drawer built into a light oak kitchen island under a marble counter in a US home, the microwave drawer slid fully open toward the camera to show its flat interior with a plain covered glass casserole dish inside, the control strip along the top edge of the microwave blank or showing plain digits only. GE Profile builds this

Microwave drawer

A microwave built under a counter or into a kitchen island that opens like a drawer at the touch of a key, with a motor and gears sliding its cavity out toward you.

In GE Profile's own words

The control detected that the door has not been opened (food/beverage has not
GE Profile PEB7227 built-in and PES7227 countertop microwave owner's manual GE Profile PWL1126 microwave drawer owner's manual

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. The FOOD prompt appears in the PEB7227, PES7227 and PEM31 tables and again in the PWL1126 drawer manual.

GE Profile FOOD microwave repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas

Tampa BayFL · 31 areas

OrlandoFL · 30 areas

Miami / South FloridaFL · 47 areas

New York MetroNY · 75 areas

HoustonTX · 36 areas

ChicagoIL · 50 areas

Los AngelesCA · 95 areas

San DiegoCA · 31 areas

San Francisco Bay AreaCA · 74 areas

A family warming plates of food at a built-in microwave in a bright kitchen
For the heart of your home.

Questions
about FOOD.

Can I clear FOOD myself?
Open the door, make sure the food or drink is in place and close it firmly.
Why does my GE Profile microwave say FOOD when I press Start?
It has not seen the door open since the last cycle, so it assumes nothing is inside. Open and close the door and start again.
My GE Profile microwave shows FOOD even though I just opened the door. What's wrong?
The control did not register the door opening, which points at a door switch. Stop using it until a technician has checked the switches.
Can I turn off the FOOD prompt on a GE Profile microwave?
The manuals give no way to switch it off; it goes away once the control sees the door open and close.

Back to your everyday

Still showing FOOD?

Three details make the booking useful: the characters or beeps just as they appeared, every character of the model number, and whether a cup of water still warms up. With those, the technician arrives already halfway to the answer.

Schedule a repair Call (844) 393-5858
(844) 393-5858 Schedule a repair