Fisher & Paykel A1: the speed oven has run too hot
On the touch-screen Series 7 and Series 9 speed ovens, A1 is the general overheat alert.
Mon–Sat, 8am–8pm
- Sensors and temperature
- Microwave control board and touchpad repair
- Source: Fisher & Paykel
Book a visit
Three short steps, about a minute.
or call (844) 393-5858
Loading appointment form…
The appointment form couldn’t load. Please try again.
What A1
actually means.
On the touch-screen Series 7 and Series 9 speed ovens, A1 is the general overheat alert. The oven beeps, shows the code and waits for the cavity to cool and the door lock to release; the maker's own step after that is a power reset.
Fisher & Paykel microwave display
What to do when A1 shows on the microwaveKind of codeSensors and temperature
The control has stopped trusting what one of its sensors reports: the cook or humidity sensor that ends a sensor reheat when steam rises, or a thermal cutout that trips when the cavity or the magnetron runs too hot. A cutout that opens stops the microwave mid-cycle and often recovers once it cools; one that keeps tripping, or a sensor program that shuts off at once every time, needs the sensor, its wiring or the airflow behind it checked.
Usually leads toMicrowave control board and touchpad repair
Tracing a dead display, keys that do not answer or a code that keeps returning to the keypad, the ribbon, the relays or the main board, and replacing only the part that failed.
Shows up asWhat a Microwave Error Code Is Telling You
A microwave error code may be a letter and a number on the display, a lock or demo word, a row of dashes, or a beep with a blinking clock, and it can show while the microwave still heats or block every key until it is cleared.
MakeFisher & Paykel
Fisher & Paykel microwaves looked at where they are built in, with the first minutes spent on the door, its seal and the latch feel.
SourceFisher & Paykel Series 7 and 9 convection speed oven user guide (OM24NDTDX1, OM30NDTDX1 and siblings)
Printed in the use and care guide shared by the OM24NDTDX1, OM24NMTDB1, OM24NDTDB1, OM30NDTDX1, OM30NMTDB1 and OM30NDTDB1 convection speed ovens. The older OM24NDB1 and OM30NPX1 speed ovens do not list it; they report trouble as an F code kept in an event log.
Before you book,
in this order.
Each step comes from Fisher & Paykel's own guidance for A1 on its microwaves. Follow it to the end: the last card says whether this is a visit.
Leave the door shut and let the cooling fans run until they stop by themselves.
When the door has unlocked and the cavity is cool, cut power at the panel for about a minute, then restore it.
Look at the trim and the cabinet opening for anything that blocks the vent slots, such as a towel or a tight filler strip.
If A1 shows again on the next cook, write down the mode and temperature that were running and book a visit.
Still there?
It usually turns into microwave control board and touchpad repair. Book with the code and the model number.
What not to do
A1 speaks about the cavity as a whole, not about the microwave generator, which has its own alert, A5. It does not ask you to open or take apart anything: the fans and a power reset once the oven is cool are the whole owner's part.
What you may
notice with it.
The microwave problems A1 tends to arrive with. Answer these at the microwave before anyone is booked.
All problems
Where A1 usually leads
Microwave control board and touchpad repair.
Fisher & Paykel
microwaves.
Fisher & Paykel microwaves looked at where they are built in, with the first minutes spent on the door, its seal and the latch feel.
Fisher & Paykel microwave repairMore Fisher & Paykel codes
Sensors and temperature on other makes
Microwave hood combination
The microwave that hangs from the wall cabinets above the burners, heating food in its cavity while its own fan, light and filters handle the steam and grease rising from the pans beneath it.
Built-in microwave
A microwave set into a tall cabinet or a wall of cabinetry at eye level, either a countertop body wrapped in a trim kit or a true built-in model, including speed and convection microwaves that brown as well as heat.
Microwave drawer
A microwave built under a counter or into a kitchen island that opens like a drawer at the touch of a key, with a motor and gears sliding its cavity out toward you.
In Fisher & Paykel's own words
The oven has overheated.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Printed in the use and care guide shared by the OM24NDTDX1, OM24NMTDB1, OM24NDTDB1, OM30NDTDX1, OM30NMTDB1 and OM30NDTDB1 convection speed ovens. The older OM24NDB1 and OM30NPX1 speed ovens do not list it; they report trouble as an F code kept in an event log.
Fisher & Paykel A1 microwave repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about A1.
Can I clear A1 myself?
Why does my Fisher & Paykel speed oven show A1 after a long convection bake?
Can I switch the breaker off as soon as A1 appears?
Is it safe to keep using the speed oven after A1 clears?
Back to your everyday
Still showing A1?
Three details make the booking useful: the characters or beeps just as they appeared, every character of the model number, and whether a cup of water still warms up. With those, the technician arrives already halfway to the answer.