The membrane keypad beside the door of a countertop microwave, the display showing plain digits and one key worn smooth at its center.

Bosch E-11: moisture on the touch keys of a Bosch microwave

Bosch touch controls read small changes on the glass or panel surface, and a film of steam can look like a finger.

(844) 393-5858

Mon–Sat, 8am–8pm

  • Control board and touchpad
  • Microwave control board and touchpad repair
  • Source: Bosch

Book a visit

Three short steps, about a minute.

or call (844) 393-5858

What E-11
actually means.

Bosch touch controls read small changes on the glass or panel surface, and a film of steam can look like a finger. E-11 is the control noticing keys that do not behave, and Bosch expects it to clear once the panel is dry and the power is cycled.

Bosch microwave display · also shown as E11

What to do when E-11 shows on the microwave

Before you book,
in this order.

Each step comes from Bosch's own guidance for E-11 on its microwaves. Follow it to the end: the last card says whether this is a visit.

01

Dry the control panel with a dry cloth.

02

Switch the breaker off, wait about 10 seconds, and switch it back on.

03

Let steam clear from the kitchen before using the panel again.

04

If E-11 still comes back on a dry panel, book a visit for the touch control.

Still there?

It usually turns into microwave control board and touchpad repair. Book with the code and the model number.

What not to do

E-11 does not point at the magnetron or the door. It is also the one Bosch E-code that owners are told to try clearing themselves; any other number goes straight to service.

What you may
notice with it.

The microwave problems E-11 tends to arrive with. Answer these at the microwave before anyone is booked.

All problems

Where E-11 usually leads

Microwave control board and touchpad repair.

Control board, keypad membrane or display · moderate to highest.

In Bosch's own words

The touch keys are not operating properly. This may be due to condensation on the keypad.
Bosch Oven & Microwave Error Codes support page Bosch 500 Series HMC54151UC speed oven Use and Care Manual Bosch Oven & Microwave Error Codes support page

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Listed in the HMC54151UC speed oven manual and on Bosch's oven and microwave support page.

Bosch E-11 microwave repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A family warming plates of food at a built-in microwave in a bright kitchen
For the heart of your home.

Questions
about E-11.

Can I clear E-11 myself?
Dry the control panel with a dry cloth. If it comes back, it needs a visit.
Why does my Bosch speed oven show E-11 after boiling pasta?
Steam rising past a panel that sits at eye level can settle on the keys. Dry it and reset the breaker for about 10 seconds.
How long should the Bosch breaker stay off for E-11?
Bosch gives about 10 seconds, enough for the control to restart cleanly.
What if E-11 comes back on a dry Bosch panel?
Then moisture is not the cause and the touch control itself needs testing. Book a visit.

Back to your everyday

Still showing E-11?

Three details make the booking useful: the characters or beeps just as they appeared, every character of the model number, and whether a cup of water still warms up. With those, the technician arrives already halfway to the answer.

(844) 393-5858 Schedule a repair