

Bosch ENJOY YOUR MICROWAVE TOUCH CLEAR: the drawer lost power
The same message that greets you at first plug-in comes back whenever the power to the Bosch drawer was interrupted.
Mon–Sat, 8am–8pm
- Power and supply
- Microwave diagnostic visit
- Source: Bosch
Book a visit
Three short steps, about a minute.
or call (844) 393-5858
Loading appointment form…
The appointment form couldn’t load. Please try again.
What ENJOY YOUR MICROWAVE TOUCH CLEAR
actually means.
The same message that greets you at first plug-in comes back whenever the power to the Bosch drawer was interrupted. It tells you the clock, any running program and the Panel Lock have been cleared, and it keeps repeating until someone touches Stop/Clear.
Bosch microwave display · also shown as ENJOY YOUR MICRO- WAVE TOUCH CLEAR
What to do when ENJOY YOUR MICROWAVE TOUCH CLEAR shows on the microwaveKind of codePower and supply
The microwave has noticed trouble with the power reaching it: an outage or a brownout that interrupted a cycle, a voltage too low for the magnetron to start, or a supply that dipped when something else on the circuit switched on. As often as not the cause is the circuit, the outlet in the cabinet above or the breaker rather than the unit; a main fuse that blows again after a reset points inside, where only a technician goes.
Usually leads toMicrowave diagnostic visit
A visit that times a cup of water against the clock, checks the door and its switches, then tests the high-voltage section, the controls and the moving parts one at a time until a single part is named.
Shows up asWhat a Microwave Error Code Is Telling You
A microwave error code may be a letter and a number on the display, a lock or demo word, a row of dashes, or a beep with a blinking clock, and it can show while the microwave still heats or block every key until it is cleared.
MakeBosch
Bosch microwaves serviced in your kitchen, from a hood combination whose fan has gone quiet to a drawer that no longer slides out.
SourceBosch HMD8454UC / HMD8054UC drawer microwave Use and Care Manual
Bosch 800 Series drawer microwaves HMD8054UC and HMD8454UC. Bosch's troubleshooting table also lists a flashing display after a power failure.
Before you book,
in this order.
Each step comes from Bosch's own guidance for ENJOY YOUR MICROWAVE TOUCH CLEAR on its microwaves. Follow it to the end: the last card says whether this is a visit.
Touch Stop/Clear to end the message.
Set the time of day again and restart any food that was cooking.
If the message returns with no outage in the house, have the outlet and circuit checked; if the circuit is sound, book a visit.
Still there?
It usually turns into microwave diagnostic visit. Book with the code and the model number.
What not to do
This greeting is not a malfunction code. A breaker that trips again as soon as the drawer starts is a different, urgent symptom and the drawer should stay off.
What you may
notice with it.
The microwave problems ENJOY YOUR MICROWAVE TOUCH CLEAR tends to arrive with. Answer these at the microwave before anyone is booked.
All problemsWhere ENJOY YOUR MICROWAVE TOUCH CLEAR usually leads
Microwave diagnostic visit.
Bosch
microwaves.
Bosch microwaves serviced in your kitchen, from a hood combination whose fan has gone quiet to a drawer that no longer slides out.
Bosch microwave repairMore Bosch codes
Power and supply on other makes
Microwave hood combination
The microwave that hangs from the wall cabinets above the burners, heating food in its cavity while its own fan, light and filters handle the steam and grease rising from the pans beneath it.
Built-in microwave
A microwave set into a tall cabinet or a wall of cabinetry at eye level, either a countertop body wrapped in a trim kit or a true built-in model, including speed and convection microwaves that brown as well as heat.
Microwave drawer
A microwave built under a counter or into a kitchen island that opens like a drawer at the touch of a key, with a motor and gears sliding its cavity out toward you.
In Bosch's own words
Simply touch the stop/clear key and reset the clock.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Bosch 800 Series drawer microwaves HMD8054UC and HMD8454UC. Bosch's troubleshooting table also lists a flashing display after a power failure.
Bosch ENJOY YOUR MICROWAVE TOUCH CLEAR microwave repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about ENJOY YOUR MICROWAVE TOUCH CLEAR.
Can I clear ENJOY YOUR MICROWAVE TOUCH CLEAR myself?
Why does my Bosch drawer show ENJOY YOUR MICROWAVE out of nowhere?
Do I lose my Bosch drawer settings after an outage?
My Bosch drawer greeting keeps coming back. What now?
Back to your everyday
Still showing ENJOY YOUR MICROWAVE TOUCH CLEAR?
Three details make the booking useful: the characters or beeps just as they appeared, every character of the model number, and whether a cup of water still warms up. With those, the technician arrives already halfway to the answer.